Engineering RFQs answered within 1 business dayrfq@technicalfoamservices.com

Capabilities

PSA adhesive lamination & multi-layer assembly

Most foam parts are only as good as the adhesive behind them. The choice comes down to one property of the foam: its surface energy.

Surface energy decides the adhesive

Pressure-sensitive adhesives wet out and bond well on high-surface-energy substrates (polyurethane, metals, ABS, painted surfaces). Polyethylene, cross-linked PE, EPDM and polypropylene are low-surface-energy (LSE): standard acrylics bead up on them and peel at a fraction of their rated strength. Silicone foam is a third case: almost nothing sticks to it except a silicone adhesive.

Hands working a sheet of foam material

Adhesive selection table

AdhesiveChemistry / thicknessBonds well toTypical foam pairing
3M 467MP200MP acrylic, 2 mil (0.002")Metals, high-SE plastics, PUPORON®, polyurethane, neoprene on metal enclosures
3M 468MP200MP acrylic, 5 mil (0.005")As 467MP, plus textured or rougher surfacesThicker PU and neoprene, textured housings
3M 9474LE300LSE acrylic, ~6.7 milLow-SE plastics, powder coat, oily metalPlastazote® / XLPE, ESD PE, EPDM sponge, EVA
Silicone / acrylic dual-linerSilicone PSA on the foam side, acrylic on the mating sideSilicone foam to metal or plasticBISCO® HT-800 and other cellular silicones
Lamination adds 0.002" (467MP) to 0.005" (468MP) to the stack; specify the finished thickness on the drawing including adhesive.

The most common foam field failure we see: 3M 467MP or 468MP laminated to XLPE, EPDM or BISCO® silicone. It passes incoming inspection and lifts weeks later. The cost estimator warns when this pairing is selected.

What lamination adds to the cost

On short runs a roll setup of $50–$150 applies. Adhesive itself adds roughly 22% (467MP) to 45% (silicone dual-liner) to the foam cost per part, with a floor of about $0.45–$1.40 per square foot of tape depending on type. The adhesive is laminated across the full sheet before cutting, so nesting yield applies to the tape as well as the foam.

Liners and kiss-cut parts

  • Liner type: densified kraft for flat sheets, polycoated or PET film liners for kiss-cut parts and automated dispensing.
  • Kiss-cut on liner: parts are cut through the foam and adhesive but not the liner; see die cutting & kiss-cutting.
  • Lift tabs and extended liners speed up manual assembly; specify them on the drawing.

Multi-layer assemblies

Laminated stacks

Foam + PSA + foam builds for stepped inserts or combined properties: a firm PORON® layer for compression over a soft layer for conformance, or an acoustic absorber on a closed-cell skin.

Facings

Aluminium foil facings on acoustic and thermal foams, PET film for wipe-clean surfaces, scrim for tear strength on large die-cut parts. Heat-welded laminates join XLPE layers without adhesive where outgassing matters.

Surface preparation on your assembly line

Even the right adhesive fails on a dirty surface. Recommend a 50/50 isopropyl alcohol / water wipe on the mating surface, firm roll-down pressure (about 15 psi), and application above 15°C (60°F). Acrylic PSAs build strength over 24–72 hours.